Aktueller Inhalt von Szem

Here is my review of the Magicshine MJ-870 & MJ-872 (both from DX). It is a short version for full version click here : => Magicshine MJ-870 and MJ-872 - magic 1000+ lumens from 3 and 4 Cree XP-G leds. :daumen: Some marketing data. Close up : A bit closer ;) Very close...

On the wall the beam shape is ugly, but on the ground is just right... :daumen:

HL-EL500G on batteries, Luxeon I or III on board. HL-EL500G on batteries, Cree XP-G R4 on board. messias, only led replacement, I've used xg-p on small 10x5 mm mcpcb and press it with the old slightly cut holder.

Luxeon I -> Cree XP-G R4 :)

It doesn’t switch to lower mode - the temperature-sensitive resistor lowers the current to lower the body temperature.

According to Petzl manual : Level Brightness Range Time* Time** Reg. 1 8 lumen 23 m 35 h 95 h + 2 13 lumen 28 m 22 h 70 h + 3 17 lumen 39 m 16 h 65 h + 4 25 lumen 45 m 10 h 60 h + 5 34 lumen 56 m 4 h 58 h...

If it is avalible in Poland, so it should be avalible in Germany too... These year Petzl move his lazy corporate ass earlier and we have new headlamp available in December, not in January. :daumen: So, the good old Myo XP revision 3 looks like that : From outside, they only change...

For 4,5 EURO you can get 18650 Li-Ion cell 2400mAh weight 44 g diameter 18 mm height 65 mm so 44mAh / g and 533 mAh/EURO This KONION LITHIUM-IONEN-MANGANZELLEN 3,9V 2900mA costs 17 euro... weight 92 g diameter 26 mm height 70 mm so 31mAh / g and 170 mAh/EURO Nice find....:lol:

Strange value... For PL-Silver on high current is set by resistor and 1000mA from Li-Ion Pack 7,2V isn't strange... I measure PLB at 8+ V and it was only slightly over 900 mA. But yes, it will be around 400 lumens.

Maybe because this new cool black look... Most people were expecting that Sigma would do similar thigh to Hope – they powered their Hope Vison One Led at 1000mA and use U-bin SSC – that will give more than 200 lumens of light... But as we can see the reality is a bit different.

siq there will be no V-bin in nearest future - they are going to release U2 bin - 119-128 lumens @ 350mA in second quarter this year.

Hmm maybe, Who is gone to heat up his PLB and check it ? :D.

It doesn't work this time.... rubber was tired to pieces during unscrewing.

Screw that... how much glue is too much ??? :mad: Yes as you can see they greed 1 EURO for U-bin SSC and put there TSW0H :rolleyes: - there is enough glue on thread that unscrewing the top cap is almost impossible without damaging it - as you can see on the photos. It looks...

Friend of mine was able to open his PLB an there was T-bin SSC - it isn't strange for me, they do the same with old PL using S-bin Lux III.