broken spv?

Registriert
26. Februar 2006
Reaktionspunkte
0
Hello:

Sorry ,I writing in english because I am from out of germany and I do not know german. `:)


I have got ´04 manitou sherman fork with problem that I can not identify.

It makes strange sound as "cloc!" when rebound starts, and rebound adjust not works.

I dismount the fork and check the spv valve. All parts have a good appearance.

I have a doubt about the blue spv valve. I dont know if must be air into this part and the fixed grey part, between both, or must be this chamber filled with oil...

any suggestion is welcome...

(I prefer ansewers in english please )

thanks
 
Sorry for bad english.
The "Cloc"-sound is typical for problems with increased air pressure inside the blue spv-valve. Inside the small chamber must be air with normal pressure, no oil. Increased Pressure or amount of oil inside will result in the "cloc".
 
Principle of SPV is that you have normal air pressure in the spv valve. If you pressurize the oil chamber, the SPV valve is pressed against the piston with a force relative to the SPV pressure. So you can adjust the platdorm by increasing or decreasing SPV pressure.

The problem is, that if your SPV valve doesn't close, you will have rebound oilflow through the compression piston.

This occurs when:
you ride without SPV pressure
your SPV valve has been pressurized 'cause of bad seelings
your SPV valve has been filled with oil 'cause of bad seelings

how to check:
increase your SPV pressure and see if rebound works again
or
try to press the blue SPV against the piston and check if it closes the gap completely, this should not require too much force. Then it should go back to normal position as shown in the manual.


what to do:
dismantle the SPV valve, clean it, assemble it with a thin layer of grease and try again.
 
Newsletter

Die neuen Artikel jeden Morgen per Mail

Gegen 9 Uhr kommen alle Tests und News von MTB-News.de in dein Postfach. Kostenlos, jederzeit abbestellbar.

Zurück