Suche Steuersatz 1 1/8 Gewinde flach

[Steelrider1]

Hola!

Ich bin auf der Suche nach einem Steuersatz passend für 1 1/8 mit Gewinde in schwarz und jetzt kommt der interessante Punkt. Die Einbauhöhe sollte nicht mehr als 33 mm betragen.

Gerne auch Hinweise auf einen passenden.

Gruß

Micha

 

[BikingDevil]

Ritchey Logic EC30
https://www.chainreactioncycles.com...EmrdEDGvBYznM2pH5hc25JoiWE01r1o4aApnDEALw_wcB

 

[cbb]

Hi, if this helps you, Im selling this one on ebay:
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.de/ulk/itm/274189029797
The lower is 11mm height, the upper is 23mm, thus the stack-height is 34mm.
Hope it helps you. Since re-anodized and cleaned not has been installed nor used.
Peter

 

[Steelrider1]

Hello Peter.

Thanks for your note. Do you know if the lower bearing is sealed and which kind of bearing is it? (Balls or Roller)

Regards

Micha

 

[cbb]

Hallo Micha, no, sorry, the lower bearings are balls (think its visible on one of the pictures). This is old-style headset type, but when you find suitable roller bearing or lower cap, you can swap it. Hope it helps.

EDIT: My mistake, Im sorry, I looked at wrong picture of another headset I sell, too. The one Im offering you here has sealed lower bearing, no balls. Please, appologise, my hands were quicker than my brain